In article ,
Kurgan Gringioni wrote:

On Dec 6, 12:48*pm, "Tom Kunich" cyclintom@yahoo. com wrote:
"Kurgan Gringioni" wrote in message

...



If you were even a half decent engineer, you'd figure out that it's
fast and easy to pinpoint a set of bearings that will outlast the rest
of the wheelset, buy them with a few clicks of the mouse and install
them.

I do find it comical that you haven't the slightest clue what you're talking
about but don't have a problem demonstrating it to everyone else.

If only you knew. If you're ever in San Diego, I'll show you around
the shop. It's likely, deduced from the content of your posts, that
you don't know how most of the **** works.

How bizarre was that? You post a simple solution to the "problem" he was whinging
about and he says *you* don't have a clue? Tom's connection to reality when it comes
to things like this is tenuous, at best. Like the time he insisted that Look makes
the molds for their cleats on manual mills in North Africa and that I didn't "have a
clue" about how molds are made. I think you know a bit about what my knowledge level
is in machining.

--
tanx,
Howard

Caught playing safe
It's a bored game

remove YOUR SHOES to reply, ok?