On Sat, 15 Sep 2018 22:32:23 -0400, Frank Krygowski
wrote:

FWIW, I had to fabricate a plug for an oddball 12V DC connector for an
old piece of equipment. After cobbling together the metal contacts, I
used Sugru to mold a rubberish plug that held the contacts in the right
position. It's worked well.

Yep, that will work. I've used Sugru a few times but found it to be
rather expensive. So, I use RTV, Devcon something hard rubber molding
goo, Bondo (for a rock hard connector),
https://makezine.com/projects/make-40/fond-o-bondo/
various casting compounds, some weird stuff I picked up at a crafts
fai
https://www.smooth-on.com
urethane molding goo, acrylic resin, etc. For contacts, I use the
remains of the old power connector, or I fabricate something out of
brass strips, tubing, and shrink tube for insulation. Just about any
casting compound will work, as long as you use sufficient mold release
to keep it from sticking to the form. I made about ten crude power
connectors using slightly tapered holes drilled into a block of wood
as a form. The first 10 connectors came out of the mold easily.
However, I forgot to add more mold release on the 2nd batch and had to
chisel the connectors out of the forms. No matter how much I sand or
tape the shells, I continue to get splinters in my fingers when I
forget and just grab the shell.



--
Jeff Liebermann
150 Felker St #D http://www.LearnByDestroying.com
Santa Cruz CA 95060 http://802.11junk.com
Skype: JeffLiebermann AE6KS 831-336-2558