m-gineering wrote:
Stan Cox wrote:
Hi all
I got a bit carried away in the Geoffrey Butler January 20% off
everything sale. I "saved" over £500 I am in the process of building
up my lovely new Look bike. I bought a Look Ergopost Ti to go with it
and am a bit concerned about overtightening it. The instructions say
to tighten to 2 m.daN I have no idea what this means. I certainly dont
have a torque wrench that goes that low. What is the best way of
getting this tight without doing damage? TIA
Stan Cox
P.s. Just did a search in google for m.daN and it told me that Dan is
short for Daniel
daN is a very complicated way of saying Kilo (deca Newton ie Newton *
10)
20 Nm= 14 lbsft
If you don't go beserk with a short allan key you should be ok
Aahh, Thank you very much. If they had just said 20nm I would have
understood. I am much more likely to undertighten it out of caution
Stan Cox