|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Bar Ends: Flush or slightly inset?
I think I've figured out how wide I want my bars and right now there's about
1.5" of bar sticking out from each bar end. I'm going to trim the bars with a pipe cutter. Should I leave, say, 1/4" sticking out past the bar ends or cut them flush? I guess this is an engineering question about the collapsability of the bar tubing under the load of pulling on the bar ends when climbing. -- PeteCresswell |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Rec.Bicycles Frequently Asked Questions Posting Part 1/5 | Mike Iglesias | General | 4 | October 29th 04 07:11 AM |
Bar Ends: Something to compensate for sweep? | (Pete Cresswell) | Mountain Biking | 3 | June 19th 04 03:33 AM |
Increasing distance? | Doki | UK | 47 | April 1st 04 09:09 AM |
Fitting bar ends, to cut or not | Slash | Mountain Biking | 13 | August 12th 03 10:01 AM |