|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Shimano OB crank installation?
Man, I'm confused. I know, what else is new...
I installed my bearings, then fitted the cranks (yes, I did follow Shimano's instruction sheet), but there isn't much interface between the the spindle gear shaft and non-drive side crank. http://www.pbase.com/slack/image/83685940/original Is this normal. Also, I measured the crank arm clearance between the cranks and the rear tri: Drive side Non-Drive ..413" .554" And I used only one spacer on the non-drive per Shimano's instruction for a 68mm shell. What the heck? What I do wrong (shut up JD)? Do I just removel the 2.5mm spacer? help... please -- Slack |
Ads |
#2
|
|||
|
|||
Shimano OB crank installation?
On Fri, 10 Aug 2007 20:25:40 -0700, â–€Slack wrote:
http://forums.mtbr.com/showthread.ph...=1#post3400066 AMB = 0 Mtb-Retards = 1 No wonder everyone abandoned AMB (shut up JD) -- Slack |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
shimano 7410 crank and BB | erikv | Techniques | 0 | September 26th 06 10:32 PM |
Shimano cartridge bb installation - How to? | Sir Ridesalot | Techniques | 3 | July 20th 06 02:52 AM |
Shimano 6-7-8 chain connecting pin and careless installation | Ben Pfaff | Techniques | 3 | February 16th 06 05:46 AM |
Truvativ Rouleur BB/Crank installation question | kj | Techniques | 3 | November 24th 05 03:05 PM |
New Crank From Shimano | B. Lafferty | Racing | 0 | September 28th 05 12:21 AM |