|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
converting XTR top pull to top & bottom pull ?
I have an old 9 speed deore front mech with a top and bottom pull assembly.
However, I can get a cheap XTR mech but this is top pull only. Can I swap over the wire clamping assembly converting the XTR to top and bottom pull ? Thanks C |
Ads |
#2
|
|||
|
|||
"freddie_fandango" wrote in message ... I have an old 9 speed deore front mech with a top and bottom pull assembly. However, I can get a cheap XTR mech but this is top pull only. Can I swap over the wire clamping assembly converting the XTR to top and bottom pull ? I dunno about the conversion, but XTR front mechs really only work well with non-compact drive (XTR) rings. You would be better served sticking with the XT unless you upgrade your crankset as well. Mike |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Ultegra bottom bracket installation problem | Floyd Sense | Techniques | 1 | August 3rd 04 06:57 AM |
Top pull derailleur for Ultegra triple crank? | L. Smythe | Techniques | 6 | August 31st 03 07:20 PM |
Top pull derailleur for Ultegra triple crank? | L. Smythe | General | 0 | August 19th 03 04:49 AM |