|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Di2 multishift issues - Setup 6770 with external battery and old Junct-A
I had issues with setting up a friends bike to do multishift and change the speed of shifting using the PCE-1 hardware.
I was able to upload all the new firmware to date (08-22-16). Had some issues programming the rear deraillur till i did a master reset using Junction Box A But I was unable to setup the bike with multishift and or changing the shift speed. When i try to upload the new setting its say incomplete and check battery if its disconnected - If its connected hit next - Battery was connected and was functioning before and after the PCE1 link. Battery was new and fully charge as well. Anyone had this issue ? (yes older 10 speed - 6770) Anyone resolved this issue ? Thanks for any advice Shimano tech did not have any solutions as well - called their tech support Same setup (my bike also 6770) Have no issues - (only difference is his external battery mount has hard wire to the mount and mine has a wire that can be disconnected (to the mount) Thanks in advance..... |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Can replace Lthium with Nimh external battery pack? | Sir Ridesalot | Techniques | 43 | October 5th 15 08:49 PM |
External-bearing BBs? | Joao de Souza | Techniques | 58 | June 11th 08 05:11 AM |
External BB bearings... | Jamie | Techniques | 6 | April 13th 06 06:57 PM |
Front shifting issues on a half-step setup | Joe LoBuglio | Techniques | 1 | June 10th 05 01:56 AM |
back issues of `Ride' - Issues 14 and 17 | David Pascoe | Australia | 2 | November 14th 03 11:31 AM |